- 11.1.5 – Premolded NACA Scoop Installation
- 11.1.5 – Premolded NACA Scoop Installation
- 11.1.5 NACA Duct modification
- 11.1 Engine Cowl Mod
- 11.1 Engine Cowl Mod
- 11.1 Engine Cowl Mod
- 11.1 Engine Cowl Mod
- 11.1 Engine Cowl
- 11.1.6 Oil Access Door
- 11.2.2 Counterweight Fairings
- 11.1.5 Premolded NACA Duct Installation
- 11.2.1 Canard Tip Installation
- 11.2.2 Elevator Counterweight Fairings
- 11.1.3 Upper Cowl Wing Flange
- 11.1.99 Cowling Baffle Treatment
- 11.1.2 Cowling attach mod
- 11.1.8 Cowling Attachments
After the two outer layers of BID had cured, I filled the low spots with micro and covered the whole area with one layer of fine BID. Looks like a Turtle. I was tempted to put a head and legs on it and leave it. 🙂
Then it was time (once again) to fill. This is after the first layer of fill has been sanded and then another layer put down and guide coat and sanding.
Now it’s getting close. I had the shape worked out and all I’m doing at this point is fixing voids and a couple minor low spots.
I REALLY hate the spotted dog. But hopefully by next week I’ll be cutting the oil access door.