7.8.4 – Landing Gear Electrical

This entry is part 12 of 39 in the series 07 - Landing Gear

I needed an easy task, so I decided to install the nose gear down switch.

The switch gets attached to the overcenter stop. I put some blue tape to make it easier to see the location I marked for the holes.

Then I removed the stop, drilled and taped the holes for 4-40 screws.

Reinstalled the stop and mounted the switch.

The up switch is going to require some creativity.

Series Navigation<< 7.7.2 Parking Brake7.8.4 Main gear microswitch wire routing >>