- 14.2.3 NO MORE SANDING!
- 14.2.3 Final primer on top
- 14.2.2 Last prep before final priming
- 14.2.2 Sanding
- 14.2.1 Sanding
- 14.2.1 Return of the Spotted Dog
- 14.2.1 Radius (Top)
- 14.2.2 Priming
- 14.2.1 Photo op
- 14.2.1 The ugly nose
- 14.2.1 Window transistion
- 14.2.3 Priming
- 14.2.1 Top side finish
- 14.2.3 More Painting
- 14.1.4 Aileron Balancing
- 14.1.4 Aileron Installation
- 14.2.3 Primer
- 14.2.3 Final Prime of the Cowling
- Back in the saddle again
- 14.0 – Punchlist
- Trip 2 completed
- 14.1.2 Tie Downs
- 14.2.1 Finishing Bottom of Airplane
- 14.2.3 Final Primer on Lower Fuselage
- 14.2.1 Strake Extension
- 14.2.1 Windows
- 14.2.1 Finishing Upper Airplane
- 14.1.10 Calibrating Fuel Tanks
- 14.99 Contact!
- 14.1.7 Vortilon Installation
- 14.99 Engine Run III
- 14.99 Placards
- 14.1.7 – Vortilon Installation
- 14.99 Weight and Balance
- 14.99 Airworthiness Inspection
- 14.99 – Painting
- 14.99 Painting
- 14.99 Painting Complete
The transition between windows and fuselage needed a lot of work. The windows are noticeably lower than the adjacent fuselage. So it was time to sand (again). Fortunately, there are only three windows.
Here’s the “before” pilot side rear window.
Here’s the after picture of the same window. Notice that much of the white filler close to the window has been removed.